Page 3 of 3 FirstFirst 123
Results 31 to 33 of 33

Thread: Installing an SYE. I think.

  1. #31
    Join Date
    Feb 2013
    Location
    Peoria, Arizona, United States
    Posts
    445

    Re: Installing an SYE. I think.

    Quote Originally Posted by Jim Nutt View Post
    Yup.

    Sent from my Pixel XL using Tapatalk
    well I have no drive shaft vibrations to worry about. Already have an HD drivesahft in the rear that the PO put on, and I am fixing some of the driveline angles this weekend. Why would I want an SYE then since its already seal. Flexing at table mesa made the slip yoke pull out on my YJ and that was the moment I realized EXACTLY why I needed an SYE.... WHy do I need it for the TJ then? Sorry in advance if I sound like a Dumb A** but I want to understand for future knowledge.

  2. #32

    Re: Installing an SYE. I think.

    Well, when I crawl under my TJ with a mere 2" lift I can see why I need one. Just sitting on level ground, the front u joint of my rear drive shaft is at a bad angle, the SYE would allow a longer drive shaft that would reduce that angle and allow the rear to drop more.

    Sent from my Pixel XL using Tapatalk

  3. #33
    Join Date
    Feb 2013
    Location
    Peoria, Arizona, United States
    Posts
    445

    Re: Installing an SYE. I think.

    Quote Originally Posted by Jim Nutt View Post
    Well, when I crawl under my TJ with a mere 2" lift I can see why I need one. Just sitting on level ground, the front u joint of my rear drive shaft is at a bad angle, the SYE would allow a longer drive shaft that would reduce that angle and allow the rear to drop more.

    Sent from my Pixel XL using Tapatalk
    Perfect, thats the answer I was looking for. In my head that made the most sense but as stated before, my YJ was for other reasons.

Page 3 of 3 FirstFirst 123

Thread Information

Users Browsing this Thread

There are currently 12 users browsing this thread. (2 members and 10 guests)

  1. roger,
  2. YJJim

Similar Threads

  1. help installing some kc lights
    By ahairymole in forum General Discussion
    Replies: 1
    Last Post: 01-28-2010, 04:23 PM
  2. installing an engine
    By ademster in forum Wrenching Party
    Replies: 20
    Last Post: 05-30-2009, 04:23 PM
  3. Help installing Tie Rod Tube
    By 06GrnRubi in forum Wrenching Party
    Replies: 22
    Last Post: 08-16-2008, 03:13 PM
  4. installing d44
    By STEVE FREEMAN in forum Wrenching Party
    Replies: 11
    Last Post: 08-05-2008, 11:30 PM
  5. Installing my cage
    By jeepin_in_az in forum Wrenching Party
    Replies: 5
    Last Post: 01-08-2004, 09:46 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •