'03 Jeep, Rubicon: No top, roll bar, windshield, doors, transmission, engine or front fenders. Tub has been Line X'd
Solid frame never bent/wrecked, with frame mods for better articulation, rear frame corners and cross member has been reinforced w/3/16th or better steel. Fuel tank has been moved up and back for better clearance, fuel tank has external spin on fuel filter.
Dynatrac ProRock 35 spline inner/outer axles, High Pinions D60's, 4.88's, ARB's Front and rear w/high cross over steering, no chipped gears.
Rokmen full length corner guards with custom sliders
Tom Woods drive shaft and near new front shaft
Nth degree springs
Currie Anti Rock
4:1 NV OR 241 transfercase: No chain slap, no gear grinding
JKS arms upper and lower all the way around
New in the box Rancho RS 9000 XL shocks
Nth degree Tummy Tuck skid plate
5 Walker Evans 8 x 17 in bead locks with rock crawling domes, with...
5 BFG KM2's, 4 with less than 4k miles, 5th has never been on the ground, still has paper on tread. Bought at Discount Tire and they come with certs on all 5, have NEVER needed balancing, never had a flat no slow leakers.
Full set of '05 Jeep Willy's OEM camo seats. These are in excellent condition they run about a $1000 a set if you can if them.
Tub is in great cond, never wrecked
This project has to go, I am not hauling it to Texas in the move. Cash and possibly a gun(s). Might part out later but not now, want to sell it as a rolling chassis
I have spare brand new drive shafts either Tom Woods or JE Reel, spare control arms JKS and many other parts.
AC and ARB's are complete w/air compressor
Custom built front and rear bumpers that are bullet proof.
Clear title, this was my DD and rock crawler up till a few month back, everything works as it should, no bad u joints, its ready to roll as is.
I am the original owner, this was an ordered Rubicon and the first one delivered to Dallas-Ft Worth in Sept of '02. It has been taken care of with all oils changed every 25k miles.
Add a roll cage, and gnarly V8 and rock...
I will in Texas later this month, but back last part of Oct.
I am asking $8500.00
You can visit my website and see a lot of the mods over the years I have made: