View RSS Feed


XJ Dana 35 to Ford 8.8 Swap

Rate this Entry
Quote Originally Posted by Pinoy59 View Post
I got the brackets and drive shaft adapter in the mail

I measured 3 11/16" from the inside of the flange and marked where the perches go, and 6.5" for where the center of the shock mounts go. I test fitted the brackets and truss, and they fit perfectly

Then I taped off the parts that need welding and gave everything 3 coats of primer and 2 coats paint

I painted the areas that the truss will cover becuase they will not be accessible once the truss is welded on. I just left about an inch unpainted where it will be welded.

Sent from my XT1526 using Tapatalk
Tags: 8.8 swap