Short Notice Wrenching Party

[iamtheonewho]

I'm going to be working on my CJ today over here in Ahwatukee if anyone is interested in watching a circus :D I'll be working on the following:

Rear output shaft bearing
Removing front and rear lift shackles
Installing stock shackles
Replacing heater core
Hopefully Fix leaking power steering resevoir(sp?)
Remove 4 degree shims from front axle (maybe, gonna see how it drives first)

Two of my buddies and I will be out in the garage probably all day, so if you're in the area and want to stop by to get a good laugh, give me a call! hehe

Greg Gaines
(480) 206-0502

[mingoglia]

I would of headed out there earlier if I knew, but my wife just left to run some errands and stuck me with the kids. I'm going to run out once the last kid goes to bed to play around with my caster and I could of messed with it over by your place then afterwards leant a hand handing you tools. Maybe next time.

Mike

[aklars1]

I also would have stopped by but didnt get a chance to check the forums this morning :( **** coulda shown off my new lift...

[iamtheonewho]

Well, I didn't give much notice, but I appreciate the interest at least :D I got almost everything done. Still have to replace the heater core and fix the PS leak. Also, while I was in the t-case I discovered there were 2 bearings on the output shaft. I only had the outter bearing and couldn't get the inner one off anyway, so only the outter got changed for now... a lot less vibration noise, but still a little bit at times. I'll have to get some more info on that and take another crack at it... was easy to get to and get out so should be a piece of cake. Anywho, thanks again for interest... ciao mein!

[Dragonfly]

I'm in Ahwatukee, I would have shown up if I wasn't working!

We should have an Ahwahtukee meet and gret sometime for all of us that live out here....

[iamtheonewho]

That's actually a great idea! I'll think of some ideas and post in general =)