PDA

View Full Version : Looking for some rock sliders

DrunkenKyle
11-18-2004, 02:18 PM
not a huge budget, but if anyone fabs these or knows where to find some "cheaper" rock sliders let me know..thanks..

ps..black if possible...oh and its for a YJ
Triple-XJ
11-18-2004, 05:11 PM
Get ahold of Kevin or Mike at Kevins offroad. (you will most likely have to leave a message)
they have some good prices, and a while back they had a set of used ones they were gonna sell.

Good luck
az02tj
11-18-2004, 05:27 PM
make some! 4" by 4" angle iron and 10 bolt and nuts is all you need.
mr_super-hunky
11-18-2004, 05:33 PM
Go to Davis salvage, get 4''x4'' angle iron @ however thick you want (1/4'' ? )

They will even cut to exact length for $1.00

Drill some holes and throw in some bolts!, there is however one section you will have to cut out to fit. This will require a torch or one heck of a lot of grinding.

There is a write up on this website somewhere on how to do it. I made my own a couple of years ago for around $20.00 for the pair! If you get desperate and can't find anyone with a torch, there is a welding shop just a building or two down from Davis salvage; they can torch out this section for a small fee I'm sure.
jeepin_in_az
11-18-2004, 08:12 PM
Get ahold of Kevin or Mike at Kevins offroad. (you will most likely have to leave a message)
they have some good prices, and a while back they had a set of used ones they were gonna sell.

Good luck

Last time I talked to Mike, he is no longer working there. Just an FYI.
phoen1c1an
11-18-2004, 08:45 PM
Contact Bill Ayle. He did mine. Cheap too.
billyayle@cox.net
Tom Schenk
11-19-2004, 07:25 AM
Yep, You should definitley talk to Bill about a set of his. They are a good deal, and will bolt on without hassle.
Triple-XJ
11-21-2004, 06:04 PM
Last time I talked to Mike, he is no longer working there. Just an FYI.


Wow, less than a month ago?
jeepin_in_az
11-21-2004, 06:49 PM
Wow, less than a month ago?

I think so......
FlexyXJ
11-23-2004, 08:25 PM
I think so......


Yup. He's Outta there.


Joe
Absolute Offroad 602-248-8949
SHNIPE
11-23-2004, 08:29 PM
Contact Bill Ayle. He did mine. Cheap too.
billyayle@cox.net

How cheap? I was planning on doing my own but might be willing to pay for his services.
phoen1c1an
11-23-2004, 08:47 PM
Ask him. ;)