PDA

View Full Version : Driver drop D44 full width



Fire Ball
04-24-2009, 09:41 PM
I have a Dana 44 driver drop. I think it is from an early bronco or F150.

I picked it up from a salvage yard but decided to go HP D44 instead so I want this one gone.

It is as I got it, I haven't done anything to it yet.

55" from ball joint to ball joint.
Carrier is 3.90 and up.
Currently has 4.10 gears but they are a little pitted so might want to re gear.
Ford 8 lug drum brakes, missing one drum.
No steering but the knuckles have 2 holes on each side and seems to be higher than normal steering.

I have a BOM Number but can't find the application anywhere. I have a request in to DANA to look it up for me.

Has the weld on, not cast radius arm mounts, can just cut them off.

This is not the closed knuckle POS I got off my donor truck :)
That one I'm gonna rob parts from :D

Come and get it $125

Fire Ball
04-24-2009, 10:23 PM
I have a set of 4.88 gears I could throw in from a different axle. $50 if you buy the axle.

If I don't sell the axle I might sell separate .

Peixinho
05-14-2009, 02:13 PM
hey did you sell the axle yet... I am interested but have a few questions

as i understood the add you said it was complete minus steering and one drum. You started talking about knuckles and taking parts off a donor truck but I wanted to make sure you were not taking anything off of this axle...

Also are the 4.88 gears new or are they used out of another truck

Thanks

Dad's TJ
12-23-2009, 11:08 PM
I know its been 6 mos, but still have?