over's tj
02-08-2008, 10:05 PM
If going to 4 Peaks Clean up Sat.
just got in from garage working on Jeep motor mounts, I have them out right now with a jack under engine (I''m working on reducing a very steep rear d-shaft angle)
They are Daystar mounts 1" taller, I found that I can run them 3/4" taller by using spacers under the mounts without clearence issues
What I need:
2 aluminum blocks rough cut to, 4 5/8" x 2 1/8", 3/4" thick
I will drill holes (I guess they could be made of steel, just harder to drill)
If any one reads this before going tomorrow and has access to aluminum and a saw that would be great, long shot but great. PM me, I will check tomorrow before I go to 4 peaks clean up
If not tomorrow , but if you can help- just let me know
Of course, I would pay
Thanks
Jim
just got in from garage working on Jeep motor mounts, I have them out right now with a jack under engine (I''m working on reducing a very steep rear d-shaft angle)
They are Daystar mounts 1" taller, I found that I can run them 3/4" taller by using spacers under the mounts without clearence issues
What I need:
2 aluminum blocks rough cut to, 4 5/8" x 2 1/8", 3/4" thick
I will drill holes (I guess they could be made of steel, just harder to drill)
If any one reads this before going tomorrow and has access to aluminum and a saw that would be great, long shot but great. PM me, I will check tomorrow before I go to 4 peaks clean up
If not tomorrow , but if you can help- just let me know
Of course, I would pay
Thanks
Jim