TJ Clutch/Tranny question

[coollmnade]

Quiz: If you were the bolt shown and you were rattling around under bell housing spacer plate (NV 3550), what/where would you need to go back to?

All I know is, it didn't sound good. Thanks.

[scully]

Here's a pic of what it looks like inside your bellhousing.
http://www.virtualjeepclub.com/attachment.php?attachmentid=17078&d=1199041163
17078


It doesn't look like the bolts that are on the bearing retainer, but it does look like on of the bolts that hold the sensor on the top left hand (drivers) side.
Crawl under your jeep and run your hand along the bellhousing rim and look for the wire coming from the sensor. There should be two bolts that hold it in.
If its not that, run your hand along the bellhousing some more and look for a hole missing a bolt. Its not rocket science, but it will help narrow down the possibilities.