PDA

View Full Version : Another Thanks to Simon!!

twstdtj
11-16-2006, 01:28 PM
Well looky whats in my garage!!!!! :cool:

35 spline ARBs for my 60s and some new gears.

Big thanks to Simon and Wheelers again and again and again. :D
daniel
11-16-2006, 01:53 PM
Well looky whats in my garage!!!!! :cool:

35 spline ARBs for my 60s and some new gears.

Big thanks to Simon and Wheelers again and again and again. :D

At last :cool:So when are you going to take to get them put in? Can you bring yourself bown to roll with poor folk that don't have locker:D
4 Wheelers Supply
11-16-2006, 01:54 PM
Well looky whats in my garage!!!!! :cool:

35 spline ARBs for my 60s and some new gears.

Big thanks to Simon and Wheelers again and again and again. :D

Jeff, I just talked to Mike in our service department. He has some openings. You might want to call him!!:)
1tuffxj
11-16-2006, 06:52 PM
what no thanks to Richard?????? I carried one of those boxes damit... J/K
xFallen
11-16-2006, 07:23 PM
Well looky whats in my garage!!!!! :cool:

35 spline ARBs for my 60s and some new gears.

Big thanks to Simon and Wheelers again and again and again. :D

Hey! What are you doing with my bling?
twstdtj
11-17-2006, 07:15 AM
what no thanks to Richard?????? I carried one of those boxes damit... J/K

Sorry Richard,



AND A BIG THANKS TO RICHARD AND SIMON FOR HELPING LOAD UP THE GEAR INTO A STUFFED TRAILBLAZER!!!!!!!!!!! :D
twstdtj
11-17-2006, 07:22 AM
Hey! What are you doing with my bling?

Dont hate me cause Its pretty!!!!!!!!!!!!!

:D
DAKOTA
11-17-2006, 07:28 AM
Since were on 60 stuff , any idea were GM put the numbers on a 60 ?? I have lots of cleaning to due but would like to find out exactly what and when it was in .
xFallen
11-17-2006, 07:59 AM
Since were on 60 stuff , any idea were GM put the numbers on a 60 ?? I have lots of cleaning to due but would like to find out exactly what and when it was in .

It'll be stamped on the long tube usually where Dana/Spicer puts it unless someone changed out the tube at some point. Sometimes the BOM is on the short tube although supposedly it is supposed to be one the right hand tube or the long tube only. I think it can be anywhere. It is also supposed to be facing back, but don't rely on that either since tubes can spin in the housing over time. The BOM of my front D60 (with a spun tube) was on top.

I found the BOM for my rear FF D60 on the housing where it is not supposed to be. Dunno what's up with that.


Barry